ADC

Bind/unbind a service to/from a load balancing virtual server

August 20, 2024

Contributed by:

C C S

You must bind a service to the load balancing virtual server. This enables the load balancer to forward the request to the server that the service represents. If your configuration changes, you can unbind a service from the load balancing virtual server.

Bind a service to a load balancing virtual server by using the CLI

At the command prompt, type:

-  bind lb vserver <name> <serviceName>
-  show lb vserver [<name>]
<!--NeedCopy-->

Example:

> bind lb vserver vserver-LB-CR service-HTTP-1
 Done
> show lb vserver Vserver-LB-CR
        Vserver-LB-CR (10.102.20.30:80) - HTTP  Type: ADDRESS
        State: DOWN
        Last state change was at Fri Jul  2 08:47:52 2010
        Time since last state change: 0 days, 00:42:25.610
        Effective State: DOWN
        Client Idle Timeout: 180 sec
        Down state flush: ENABLED
        Disable Primary Vserver On Down : DISABLED
        Port Rewrite : DISABLED
        No. of Bound Services :  1 (Total)       0 (Active)
        Configured Method: LEASTCONNECTION
        Mode: IP
        Persistence: NONE
        Vserver IP and Port insertion: OFF
        Push: DISABLED  Push VServer:
        Push Multi Clients: NO
        Push Label Rule: none

1) Service-HTTP-1 (10.102.29.40: 80) - HTTP State: DOWN Weight: 1
 Done
<!--NeedCopy-->

Unbind a service from a load balancing virtual server by using the CLI

To unbind a service, use the unbind lb vserver command instead of bind lb vserver.

Bind/unbind a service from a load balancing virtual server by using the GUI

Navigate to Traffic Management > Load Balancing > Virtual Servers
In the details pane, select the virtual server from which you want to bind/unbind the service, and then click Open.
On the Services tab, in the Active column, select/clear the check box next to the Service Name.
Click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Bind/unbind a service to/from a load balancing virtual server

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Bind/unbind a service to/from a load balancing virtual server

Bind a service to a load balancing virtual server by using the CLI

Unbind a service from a load balancing virtual server by using the CLI

Bind/unbind a service from a load balancing virtual server by using the GUI

In this article