ADC

Monitor the Bridge Table and Changing the Aging time

August 1, 2023

Contributed by:

NetScaler appliance bridges frames on the basis of bridge table lookup of the destination MAC address and the VLAN ID. However, the appliance performs forwarding only when Layer 2 mode is enabled.

The bridge table is dynamically generated, but you can display it, modify the aging time for the bridge table, and view bridging statistics. All the MAC entries in the bridge table are updated with the aging time.

To set the aging time of bridge table entries by using the CLI:

At the command prompt, type:

set l2param -bridgeagetimeout <positive_integer>
show l2param

Example:

> set l2param -bridgeagetimeout 90
 Done
<!--NeedCopy-->

To view the statistics of a bridge table by using the CLI:

At the command prompt, type:

stat bridge

To set the aging time of bridge table entries by using the GUI:

Navigate to System > Network. On the Network page, in the Settings section, click Configure Layer2 Parameters and set the Timeout Value For The Bridge Table Entries (seconds) parameter.

To view the statistics of a bridge table by using the GUI:

Navigate to System > Network > Bridge Table, select the MAC address, and click Statistics.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Monitor the Bridge Table and Changing the Aging time

August 1, 2023

Contributed by:

August 1, 2023

Contributed by:

Monitor the Bridge Table and Changing the Aging time

In this article