Citrix SD-WAN

Setup Branch Nodes

May 5, 2021

Contributed by:

S C

This chapter provides instructions for adding and configuring the branch sites. The procedure for adding a branch site is very similar to creating and configuring the MCN site. However, some of the configuration steps and settings do vary slightly for a branch site. In addition, once you have added an initial branch site, for sites that have the same appliance model you can use the Clone (duplicate) feature to streamline the process of adding and configuring those sites.

As with creating the MCN site to set up a branch site you must use the Configuration Editor in the Management Web Interface on the MCN appliance. The Configuration Editor is available only when the interface is set to MCN Console mode.

Supplemental Branch Site Deployment Information

In addition to this guide, the following Knowledge Base support articles are also recommended:

Virtual WAN PBR Mode Deployment Steps (CTX201577)

http://support.citrix.com/article/CTX201577
Virtual WAN Gateway Mode Deployment Steps (CTX201576)

http://support.citrix.com/article/CTX201576

Overview of Branch Site Configuration Procedures

The steps to complete this process are as follows:

Add the branch site.
Configure the Virtual Interface Groups for the branch site.
Configure the Virtual IP Addresses for the branch site.
(Optional) Configure the LAN GRE Tunnels for the branch site.
Configure the WAN Links for the branch site.
Configure the Routes for the branch site.
(Optional) Configure High Availability for the branch site.
(Optional) Clone the new branch site to create and configure additional sites.

Note

Cloning the site is optional. The Virtual WAN appliance models must be the same for both the original and the cloned sites. You cannot change the specified appliance model for a clone. If the appliance model is different for a site, you must manually add the site.
Resolve any configuration Audit Alerts.
Save the completed configuration.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Setup Branch Nodes

May 5, 2021

Contributed by:

S C

May 5, 2021

Contributed by:

S C

Setup Branch Nodes

Supplemental Branch Site Deployment Information

Overview of Branch Site Configuration Procedures

In this article