Gateway

Adding or removing route monitors

January 8, 2024

Contributed by:

When the appliances of a high availability pair reside on different networks, the high availability state of NetScaler Gateway depends on if the appliance can be reached or not. In a cross-network high availability configuration, a route monitor on each NetScaler Gateway scans the internal routing table to make sure that an entry for the other NetScaler Gateway is always present.

To add a route monitor

In the configuration utility, on the Configuration tab, in the navigation pane, expand System and then click High Availability.
In the Bind/Unbind Route Monitors dialog box, on the Route Monitors tab, click Action, and then click Configure.
Under Specify Route Monitor, in Network, type the IP address of the network of the other NetScaler Gateway appliance.

To configure an IPv6 address, click IPv6 and then type the IP address.
In Netmask, type the subnet mask of the other network, click Add and then click OK.

When this procedure is complete, the route monitor is bound to NetScaler Gateway.

Note: When a route monitor is not bound to a NetScaler Gateway, the high availability state of either appliance is determined by the state of the interfaces.

To remove a route monitor

In the configuration utility, on the Configuration tab, in the navigation pane, expand System and then click High Availability.
On the Route Monitors tab, click Action, and then click Configure.
Under Configured Route Monitors, select the monitor, click Remove and then click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Adding or removing route monitors

January 8, 2024

Contributed by:

January 8, 2024

Contributed by:

Adding or removing route monitors

To add a route monitor

To remove a route monitor

In this article