ADC

Enabling authentication, authorization, and auditing

To use the authentication, authorization, and auditing - Application Traffic feature, you must enable it. You can configure authentication, authorization, and auditing entities—such as the authentication and traffic management virtual servers—before you enable the authentication, authorization, and auditing feature, but the entities will not function until the feature is enabled.

To enable authentication, authorization, and auditing by using the command line interface

At the command prompt, type the following commands to enable authentication, authorization, and auditing and verify the configuration:

  • enable ns feature AAA

  • show ns feature

    Example

-  enable feature AAA

     Done

-  show ns feature

        Feature                  Acronym              Status
        -------                  -------              ------
        1)  Web Logging            WL                   OFF
        2)  Surge Protection       SP                   ON
         .
         .
         .
        15)  AAA                  AAA                   ON
         .
         .
         .
        23)    HTML Injection     HTMLInjection         ON
        24)    NetScaler Push      push                 OFF
 Done
<!--NeedCopy-->

To enable authentication, authorization, and auditing by using the configuration utility

  1. Navigate to System > Settings.
  2. In the details pane, under Modes and Features, click Change Basic Features.
  3. In the Configure Basic Features dialog box, select the Authentication, Authorization and Auditing check box.
  4. Click OK.
Enabling authentication, authorization, and auditing