ADC

Rate Limiting for traffic domains

You can configure rate limiting for traffic domains. The following expression in the Citrix ADC expressions language for identifies traffic associated with traffic domains.

  • client.traffic_domain.id

You can configure rate limiting for traffic associated with a particular traffic domain, a set of traffic domains, or all traffic domains.

For configuring rate limiting for traffic domains, you perform the following steps on a Citrix ADC appliance by using the configuration utility or the Citrix ADC command line:

  1. Configure a stream selector that uses the client.traffic_domain.id expression for identifying the traffic, associated with traffic domains, to be rate limited.
  2. Configure a rate limit identifier that specifies parameters such as maximum threshold for traffic to be rate limited. You also associate a stream selector to the rate limiter in this step.
  3. Configure an action that you want to associate with the policy that uses the rate limit identifier.
  4. Configure a policy that uses the sys.check_limit expression prefix to call the rate limit identifier, and associate the action with this policy.
  5. Bind the policy globally.

Consider an example in which two traffic domains, with IDs 10 and 20, are configured on Citrix ADC NS1. On traffic domain 10, LB1-TD-1 is configured to load balance servers S1 and S2; LB2-TD1 is configured to load balance servers S3 and S4.

On traffic domain 20, LB1-TD-2 is configured to load balance servers S5 and S6; LB2-TD2 is configured to load balance servers S7 and S8.

The following table lists some examples of rate limiting policies for traffic domains in the example setup.

Purpose CLI command
Limit the number of requests to 10 per second for each of the traffic domains. add stream selector tdratelimit-1 CLIENT.TRAFFIC_DOMAIN.ID add ns limitIdentifier limitidf-1 -threshold 10 -selectorName tdratelimit-1 -trapsInTimeSlice 0 add responder policy ratelimit-pol “sys.check_limit(\“limitidf-1\”)” DROP bind responder global ratelimit-pol 1
Limit the number of requests to 5 per client per second for each of the traffic domains. add stream selector tdandclientip CLIENT.IP.SRC,CLIENT.TRAFFIC_DOMAIN.ID add ns limitIdentifier td_limitidf -threshold 5 -selectorName tdandclientip -trapsInTimeSlice 5 add responder policy tdratelimit-pol “sys.check_limit(\“td_limitidf\”)” DROP bind responder global tdratelimit-pol 2
Limit the number of requests sent for a particular traffic domain (for example traffic domain 10) to 30 requests every 3 seconds. add stream selector tdratelimit CLIENT.TRAFFIC_DOMAIN.ID add ns limitIdentifier td10_limitidf -threshold 30 -timeSlice 3000 -selectorName tdratelimit -trapsInTimeSlice 5 add responder policy td10ratelimit “client.traffic_domain.id==10 && sys.check_limit(\“td10_limitidf\”)” DROP bind responder global td10ratelimit 3
Limit the number of connections to 5 per client per second for a particular traffic domain (for example traffic domain 20). add stream selector tdandclientip CLIENT.IP.SRC CLIENT.TRAFFIC_DOMAIN.ID add ns limitIdentifier td20_limitidf -threshold 5 -mode CONNECTION -selectorName tdandclientip -trapsInTimeSlice 5 add responder policy td20_ratelimit “client.traffic_domain.id==20 && sys.check_limit(\“td20_limitidf\”)” DROP bind responder global td20_ratelimit 4
Rate Limiting for traffic domains