ADC

Using cluster LA channel with linksets

August 20, 2024

Contributed by:

C C S

In an asymmetric cluster topology, some cluster nodes are not connected to the upstream network. In such a case, you must use linksets. To optimize the performance, you can bind the interfaces that are connected to the switch as a cluster LA channel and then bind the channel to a linkset.

To understand how a combination of cluster LA channel and linksets can be used, consider a three-node cluster for which the upstream switch has only two ports available. You can connect two of the cluster nodes to the switch and leave the other node unconnected.

Note

Similarly, you can also use a combination of ECMP and linksets in an asymmetric topology.

Figure 1. Linksets and cluster LA channel topology

localized image

To configure cluster LA channel and linksets by using the Citrix ADC command line

Log on to the cluster IP address.
Bind the connected interfaces to a cluster LA channel.
```
add channel CLA/1 –ifnum 0/1/2 1/1/2
```
Bind the cluster LA channel to the linkset.
```
add linkset LS/1 -ifnum CLA/1
```

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Using cluster LA channel with linksets

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Using cluster LA channel with linksets

To configure cluster LA channel and linksets by using the Citrix ADC command line

In this article