Citrix SD-WAN

USB reimage utility

March 12, 2021

Contributed by:

S C

The SD-WAN USB reimage utility allows repurposing of hardware by installing a clean factory image from a bootable USB stick. Citrix provides a USB stick Field Replaceable Unit (FRU) with a preloaded SD-WAN software image. Use the USB FRU to reimage the appliance to the required supported editions (SE/PE/AE). The appliance license/ configuration used determines the appliance edition.

The following table provides details on the available USB FRU images and the editions supported by SD-WAN appliances.

Appliance	USB FRU image	Supported Editions
Citrix SD-WAN 110	11.1.1.39	SE
Citrix SD-WAN 210	10.2.7.17	SE, AE
Citrix SD-WAN 410	10.2.3.32	SE
Citrix SD-WAN 1100	10.2.7.17	SE, PE, AE
Citrix SD-WAN 2100	10.2.7.17	SE, PE
Citrix SD-WAN 4100	10.2.7.17	SE
Citrix SD-WAN 5100	10.2.7.17	SE, PE
Citrix SD-WAN 6100	10.2.7.17	SE, PE

To perform a USB reimage:

Insert the USB stick provided by Citrix into one of the USB ports of the appliance.
Connect a USB Keyboard to another USB port.

Tip

If there is a single USB port on the appliance, use a USB splitter to connect both the USB stick and the USB keyboard.
Log into the serial console as an administrator and issue the reboot appliance command through the CLI.
On boot up continuously press the F11 key on the USB connected keyboard or SHFT+ESC+1 via serial console connection.
Select the USB drive from the boot device menu and press Enter.
Depending on the Edition supported for the platform a screen appears requesting permission to proceed with the installation. Select Yes.

Note

For PE and AE reimage, the appliance may appear in the GUI as Standard Edition until the appropriate OS and PE/AE license installation is done.

The installation takes 30 minutes to complete. Do not power off the appliance during the reimaging process. It may reboot several times.
The factory image has DHCP enabled by default. The default management IP address on all platforms is 192.168.100.1. Use it to access the SD-WAN GUI.

You can also manually configure the management IP from the serial console by issuing the following commands:

Issue command ‘management_ip’

Issue command ‘set interface 192.168.100.1 255.255.255.0 192.168.100.254’

Issue command ‘apply’
The software, by default, is upgrade to SE. Install the PE, or AE license as required depending on the editions supported by the appliance.

Note

You can configure and manage AE capabilities through the SD-WAN Orchestrator only. For more information see, Edge security.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

USB reimage utility

March 12, 2021

Contributed by:

S C

March 12, 2021

Contributed by:

S C

USB reimage utility

In this article