NetScaler VPX

Configure a NetScaler VPX instance to use PCI passthrough network interfaces

April 16, 2024

Contributed by:

After you have installed and configured a NetScaler VPX instance on the Linux-KVM platform, you can use the Virtual Machine Manager to configure the virtual appliance to use PCI passthrough network interfaces.

Prerequisites

The firmware version of the Intel XL710 NIC (NIC) on the KVM Host is 5.04.
The KVM Host supports input–output memory management unit (IOMMU) and Intel VT-d, and they are enabled in the BIOS of the KVM Host. On the KVM Host, to enable IOMMU, add the following entry to the /boot/grub2/grub.cfg file: intel_iommu=1
Run the following command and reboot the KVM Host: Grub2-mkconfig –o /boot/grub2/grub.cfg

To configure NetScaler VPX instances to use PCI passthrough network interfaces by using the Virtual Machine Manager:

Power off the NetScaler VPX instance.
Select the NetScaler VPX instance and click Open.
In the virtual_machine on KVM> window, click the i icon.
Click Add Hardware.
In the Add New Virtual Hardware dialog box, do the following:

a. Select PCI Host Device.

b. In the Host Device section, select the Intel XL710 physical function.

c. Click Finish.
Repeat steps 4 and 5 to add any additional Intel XL710 physical functions.
Power on the NetScaler VPX instance.
Once the NetScaler VPX instance powers on, you can use the following command to verify the configuration:

The output must show all the interfaces that you configured:

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Configure a NetScaler VPX instance to use PCI passthrough network interfaces

April 16, 2024

Contributed by:

April 16, 2024

Contributed by:

Configure a NetScaler VPX instance to use PCI passthrough network interfaces

Prerequisites

In this article