ADC

Removing a cluster node

September 26, 2023

Contributed by:

C S

When a node is removed from the cluster, the cluster configurations are cleared from the node (by internally running the clear ns config -extended command). The SNIP addresses, MTU settings of the backplane interface, and all VLAN configurations (except the default VLAN and NSVLAN) are also cleared from the appliance.

Note:

If the deleted node was the cluster configuration coordinator (CCO), another node is automatically selected as the CCO, and the cluster IP address is assigned to that node. All the current cluster IP address sessions are invalid and you have to start a new session.

To delete the whole cluster, you must remove each node individually. When you remove the last node, the cluster IP addresses are deleted.

When an active node is removed, the traffic serving capability of the cluster is reduced by one node. Existing connections on this node are terminated.

You can list the spotted configuration of a cluster node using the shell spottedconfig <nodeID> command and take a backup before removing the node from the cluster.

To remove a cluster node by using the CLI

Log on to the cluster IP address and at the command prompt, type:

rm cluster node <nodeId>

Example:

rm cluster node 1
All spotted configurations will be lost. Take a backup of the spotted configurations for node ID 1 using the command `shell spottedconfig 1`.
Are you sure you want to remove the cluster node (Y/N)? [N]:Y
Done

save ns config

Log on to the removed node, NSIP address, and at the command prompt, type:
```
save ns config
```

Note:

If the cluster IP address is unreachable from the node, run the rm cluster instance command on the NSIP address of that node itself.

To remove a cluster node by using the GUI

On the cluster IP address, navigate to System > Cluster > Nodes, select the node you want to remove and click Remove.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Removing a cluster node

September 26, 2023

Contributed by:

C S

September 26, 2023

Contributed by:

C S

Removing a cluster node

To remove a cluster node by using the CLI

To remove a cluster node by using the GUI

In this article