ADC

Install Routes to the NetScaler Routing Table

May 2, 2023

Contributed by:

S C

The NetScaler appliance can use routes learned by various routing protocols after you install the routes in the appliance’s routing table.

To install various routes to the internal routing table by using the VTYSH command line:

At the CLI, type the following commands as appropriate for the routes that you want to install:

Commands	Specifies
VTYSH	Display VTYSH command prompt.
configure terminal	Enter global configuration mode.
ns route-install Default	Install IPv4 default routes to the internal routing table.
ns route-install RIP	Install IPv4 RIP specific routes to the internal routing table.
ns route-install BGP	Install IPv4 BGP specific routes to the internal routing table.
ns route-install OSPF	Install IPv4 OSPF specific routes to the internal routing table.
ns route-install IPv6 Default	Install IPv6 default routes to the internal routing table.
ns route-install IPv6 RIP	Install IPv6 RIP specific routes to the internal routing table.
ns route-install IPv6 BGP	Install IPv6 BGP specific routes to the internal routing table.
ns route-install IPv6 OSPF	Install IPv6 OSPF specific routes to the internal routing table.

Example:

>VTYSH
NS# configure terminal
NS# ns route-install Default
NS(config)# ns route-install RIP
NS(config)# ns route-install BGP
NS(config)# ns route-install OSPF
NS# ns route-install IPv6 Default
NS(config)# ns route-install IPv6 RIP
NS(config)# ns route-install IPv6 BGP
NS(config)# ns route-install IPv6 OSPF
<!--NeedCopy-->

Maximum number of ECMP routes supported in a NetScaler appliance

In a NetScaler appliance up to 32 ECMP (Equal Cost Multiple Path) routes are supported. The route selection is based on five tuples. For more information, see Route selection based on five tuples.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Install Routes to the NetScaler Routing Table

May 2, 2023

Contributed by:

S C

May 2, 2023

Contributed by:

S C

Install Routes to the NetScaler Routing Table

Maximum number of ECMP routes supported in a NetScaler appliance

In this article