Citrix SD-WAN

Setting up the Appliance Hardware

March 12, 2021

Contributed by:

S C

To set up Citrix SD-WAN appliance hardware (physical appliance), do the following:

Set up the chassis.

Citrix SD-WAN Appliances can be installed in a standard rack. For desktop installation, place the chassis on a flat surface. Ensure that there is a minimum of 2 inches of clearance at the sides and back of the appliance, for proper ventilation.
Connect the Power.
1. Ensure the power switch is set to Off.
2. Plug the power cord into the appliance and an AC outlet.
3. Press the power button on the front of the appliance.
Connect the power.
1. Ensure the power switch is set to Off.
2. Plug the power cord into the appliance and an AC outlet.
3. Press the power button on the front of the appliance.
Connect the appliance Management Port to a personal computer.

You need to connect the appliance to a PC in preparation for completing the next procedure, setting the Management IP Address for the appliance.

Note

Before you connect the appliance, ensure the Ethernet port is enabled on the PC. Use an Ethernet cable to connect the SD-WAN Appliance Management Port to the default Ethernet port on a personal computer.

SD-WAN VPX-SE Management Port

The SD-WAN VPX-SE Virtual Appliance is a Virtual Machine, so there is no physical Management Port. However, if you did not configure the Management IP Address for the SD-WAN VPX-SE when you created the VPX Virtual Machine, you need to do so now, as outlined in the section, Configuring the Management IP Address for the SD-WAN VPX-SE.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Setting up the Appliance Hardware

March 12, 2021

Contributed by:

S C

March 12, 2021

Contributed by:

S C

Setting up the Appliance Hardware

SD-WAN VPX-SE Management Port

In this article