NetScaler VPX

Configure address pools intranet IP for a NetScaler Gateway appliance

September 18, 2024

Contributed by:

In some situations, users who connect with the NetScaler Gateway Plug-in need a unique IP address for a NetScaler Gateway appliance. When you enable address pools (also known as IP pooling) for a group, the NetScaler Gateway appliance can assign a unique IP address alias to each user. You configure address pools by using intranet IP (IIP) addresses.

You can configure address pools on a NetScaler Gateway appliance deployed on Azure by following this 2-step procedure:

Registering the private IP addresses that are used in the address pool, in Azure
Configuring address pools in the NetScaler Gateway appliance

Register a private IP address in the Azure portal

In Azure, you can deploy a NetScaler VPX instance with multiple IP addresses. You can add IP addresses to a VPX instance in two ways:

a. While provisioning a VPX instance

For more information about how to add multiple IP addresses while provisioning a VPX instance, see Configure multiple IP addresses for a NetScaler standalone instance. To add IP addresses by using PowerShell commands while provisioning a VPX instance, see Configure multiple IP addresses for a NetScaler VPX instance in standalone mode by using PowerShell commands.

b. After provisioning a VPX instance

After you’ve provisioned a VPX instance, follow these steps to register a private IP address in the Azure portal, which you configure as an address pool in the NetScaler Gateway appliance.

From Azure Resource Manager (ARM), go to the already created NetScaler VPX instance > Network interfaces. Choose the network interface which is bound to a subnet to which the IIP that you want to register belongs.
Click IP Configurations, and then click Add.
Provide the required details as shown in the example below and click OK.

Configure address pools in the NetScaler Gateway appliance

For more information about how to configure address pools on the NetScaler Gateway, see Configuring Address Pools.

Limitation:

You cannot bind a range of IIP addresses to users. Every IIP address that is used in an address pool must be registered.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Configure address pools intranet IP for a NetScaler Gateway appliance

September 18, 2024

Contributed by:

September 18, 2024

Contributed by:

Configure address pools intranet IP for a NetScaler Gateway appliance

Register a private IP address in the Azure portal

Configure address pools in the NetScaler Gateway appliance

In this article