NetScaler VPX

Improve SSL-TPS performance on public cloud platforms

August 28, 2024

Contributed by:

C C

You can get better SSL-TPS performance on AWS and GCP clouds by distributing the packet engine (PE) weights equally. Enabling this feature might result in a slight drop in HTTP throughput by around 10–12 %.

On AWS and GCP clouds, the NetScaler VPX instances with 10–16 vCPUs do not show any performance improvement because the PE weights are equally distributed by default.

Note:

In the Azure cloud, the PE weights are equally distributed by default. This feature does not improve any performance for the Azure instances.

Configure PE mode by using the NetScaler CLI

After setting the PE mode, you must reboot the system for the configuration changes to take effect.

At the command prompt, type:

set cpuparam pemode [CPUBOUND | Default]
<!--NeedCopy-->

When the PE mode is set to CPUBOUND, the PE weights are equally distributed. When the PE mode is set to DEFAULT, the PE weights are set to default values.

Note:

This command is node specific. In a high availability or a cluster setup, you must run the command on each node. If you run the command on CLIP, the following error occurs: Operation not permitted on CLIP

To show the state of the PE mode that is configured, run the following command:

show cpuparam
<!--NeedCopy-->

Example:

> show cpuparam
    Pemode:  CPUBOUND
 Done
<!--NeedCopy-->

Apply PE mode configuration at the first boot of the NetScaler appliance in the cloud

To apply the PE mode configuration at the first boot of the NetScaler appliance in the cloud, you must create a /nsconfig/.cpubound.conf file using the custom script. For more information, see Apply NetScaler VPX configurations at the first boot of the NetScaler appliance in cloud.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Improve SSL-TPS performance on public cloud platforms

August 28, 2024

Contributed by:

C C

August 28, 2024

Contributed by:

C C

Improve SSL-TPS performance on public cloud platforms

Configure PE mode by using the NetScaler CLI

Apply PE mode configuration at the first boot of the NetScaler appliance in the cloud

In this article