ADC

Configuring Multiple Untagged VLANs across Multiple Subnets

In environments with multiple untagged VLANs across multiple subnets, a VLAN is configured for each IP subnet. A network interface is bound to one VLAN only. The following figure shows this configuration.

Figure 1. Multiple Subnets with VLANs - No Tagging

vlan multiple subnets

To implement the configuration shown in the above figure, perform the following tasks:

  1. Add VLAN 2.
  2. Bind the 1/2 network interface of the NetScaler to VLAN 2 as an untagged network interface.
  3. Bind the IP address and subnet mask to VLAN 2.

For procedures on these tasks, see Configuring a VLAN.

Configuring Multiple Untagged VLANs across Multiple Subnets

In this article