ADC

Class E IPv4 packets

By default, the NetScaler appliance drops any packets if they contain any class E IPv4 address in the source IP or the destination IP fields. If your setup is using class E IPv4 addresses, you can configure the NetScaler appliance to process class E IPv4 packets.

Before you begin

Before you begin configuring a NetScaler appliance to process class E IPv4 packets, note the following points:

  • NetScaler appliances do not support configuring any NetScaler owned IPv4 address (for example, SNIP and VIP) in the class E range. NetScaler appliances only support processing of class E IPv4 packets.
  • A NetScaler appliance internally uses class E IPv4 addresses for the IPv6 feature. The NetScaler appliance does not support both features (processing class E IPv4 packets and IPv6 support) working at the same time. The NetScaler appliance imposes a restriction to not enable the IPv6 feature when processing of class E IPv4 packets is enabled, and vice versa.

Configuration steps

Configuring a NetScaler appliance to process class E IPv4 packets consist of the task of enabling the IPv4 Class E address clients (allowClassEIPv4) Layer 3 parameter.

CLI procedures

To configure the NetScaler appliance to process Class E IPv4 packets by using the CLI:

At the command prompt, type:

  • set l3param -allowClassEIPv4 (ENABLED DISABLED)
  • show l3param

Sample Configuration:

> set l3param -allowClassEIPv4 ENABLED

Done

> sh l3param

    Network L3 related Configuration Parameters

    icmpgen_rate_threshold      : 100

    srcnat                      : ENABLED

    override_rnat               : DISABLED

    drop_df_flag                : DISABLED

    .

    .

    .

    IPv6DynamicRouting         : DISABLED

    allowClassEIPv4            : ENABLED

Done
<!--NeedCopy-->

GUI procedures

To configure the NetScaler appliance to process Class E IPv4 packets by using the GUI:

  1. Navigate to System > Network, and then in the Settings section, click Configure Layer 3 Parameters.
  2. Select IPv4 Class E address clients and click OK.
Class E IPv4 packets