Gateway

Connect to internal network resources

January 8, 2024

Contributed by:

You can configure NetScaler Gateway to enable users to access resources in the internal network. If you disable split tunneling, all network traffic from the user device is sent to NetScaler Gateway and authorization policies determine whether the traffic is allowed to pass through to internal network resources. When you enable split tunneling, only traffic destined for the internal network is intercepted by the user device and sent to NetScaler Gateway. You configure which IP addresses NetScaler Gateway intercepts by using intranet applications.

If you are using the Citrix Secure Access client for Windows, set the interception mode to transparent. If you are using the Citrix Secure Access client for Java, set the interception mode to proxy. When you set the interception mode to transparent, you can allow access to network resources using:

A single IP address and subnet mask
A range of IP addresses

If you set the interception mode to proxy, you can configure destination and source IP addresses and port numbers.

Configure network access to internal network resources

In the configuration utility, on the Configuration tab, in the navigation pane, expand NetScaler Gateway, expand Resources, and then click Intranet Applications.
In the details pane, click Add.
Complete the parameters for allowing network access, click Create and then click Close.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Connect to internal network resources

January 8, 2024

Contributed by:

January 8, 2024

Contributed by:

Connect to internal network resources

Configure network access to internal network resources

In this article