ADC

Detecting jumbo probe on a cluster

October 21, 2024

Contributed by:

C C S

If a jumbo frame is enabled on a cluster interface, the backplane interface must be large enough to support the all packets in the jumbo frame. It is achieved by setting the Maximum Transmission Unit (MTU) of the backplane.

The configured MTU value must be the same across all nodes in the cluster for the following:

Server data plane (X)
Client data plane (Y)
Backplane: The configured MTU value must be set to 78 + a maximum of X and Y.

Note:

The MTU values for the server data plane (X) and client data plane (Y) need not be the same.

For example, if the MTU of a server data plane is 7500 and of the client data plane is 8922 across the cluster, then the MTU of a cluster backplane must be set to 78 + 8922 = 9000 across the cluster.

To verify the preceding configuration, you must send a jumbo probe (of the preceding computational size) to all the peer nodes of a cluster setup. If the probe does not succeed, the appliance displays a warning message in the output of the show cluster instance command.

In the command interface mode, type the following command:

    > show cluster instance
      Cluster ID: 1
      Dead Interval: 3 secs
      Hello Interval: 200 msecs
      Preemption: DISABLED
      Propagation: ENABLED
      Quorum Type: MAJORITY
      INC State: DISABLED
      Process Local: DISABLED
      Cluster Status: ENABLED(admin),    ENABLED(operational), UP

Warning:

The MTU for a backplane interface must be large enough to handle all packets in the frame. It must be equal to <MTU\_VAL>. If the recommended value is not user configurable, you must review the MTU value of jumbo interfaces.

Sl. no	Member Nodes	Health	Admin State	Operation State
1	Node ID: 1; Node IP: 10.102.53.167	UP	Active	ACTIVE (Configuration Coordinator)
2	Node ID: 2; Node IP: 10.102.53.168	UP	Active	Active

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Detecting jumbo probe on a cluster

October 21, 2024

Contributed by:

C C S

October 21, 2024

Contributed by:

C C S

Detecting jumbo probe on a cluster

In this article