Citrix SD-WAN WANOP

Port Parameters

March 12, 2021

Contributed by:

S C

Each bridge and motherboard port can be:

Enabled or disabled
Assigned an IP address and subnet mask
Assigned a default gateway
Assigned to a VLAN
Set to 1000 Mbps, 100 Mbps, or 10 Mbps
Set to full duplex, half-duplex, or auto (on SD-WAN WANOP 4000/5000 appliances, some ports can be set to 10 Gbps)

All of these parameters except the speed/duplex setting are set on the Configuration: IP Address page. The speed/duplex settings are set on the Configuration: Interface page.

Notes about parameters:

Disabled ports do not respond to any traffic.
The browser-based UI can be enabled or disabled independently on all ports.
To secure the UI on ports with IP addresses, select HTTPS instead of HTTP on the Configuration: Administrator Interface: Web Access page.
Inline mode works even if a bridge has no IP address. All other modes require that an IP address be assigned to the port.
Traffic is not routed between interfaces. For example, a connection on bridge apA does not cross over to the Primary or Aux1 ports, but remains on bridge apA. All routing issues are left to your routers.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Port Parameters

March 12, 2021

Contributed by:

S C

March 12, 2021

Contributed by:

S C

Port Parameters

In this article