ADC

Managing cluster heartbeat messages

May 2, 2023

Contributed by:

S C

Managing heartbeat messages in a cluster is similar to managing them in a high availability (HA) configuration. Nodes can send and receive heartbeat messages to and from each other on all interfaces that are enabled. To avoid increased traffic resulting from heartbeat messages, you can now disable the heartbeat option on node interfaces. However, the heartbeat option on the backplane interface cannot be disabled, because it is required for maintaining connectivity among the cluster nodes.

For more information about managing heart messages, see Managing High Availability Heartbeat Messages on a NetScaler Appliance.

To manage heartbeat messages on a node interface by using the NetScaler CLI

At the command prompt, type:

set interface <ID> \[-HAHeartBeat \(ON | OFF)]
Show interface <ID>

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Managing cluster heartbeat messages

May 2, 2023

Contributed by:

S C

May 2, 2023

Contributed by:

S C

Managing cluster heartbeat messages

To manage heartbeat messages on a node interface by using the NetScaler CLI

In this article