Enable the responder feature

To use the Responder feature, you must first enable it.

To enable the responder feature by using the NetScaler CLI:

At the command prompt, type the following commands to enable the responder feature and verify the configuration:

  • enable ns feature <feature>

  • show ns feature


enable ns feature Responder
> show ns feature

        Feature                        Acronym              Status
        -------                        -------              ------
 1)     Web Logging                    WL                   ON
 2)     Surge Protection               SP                   ON
 19)     Responder                      RESPONDER            ON
 20)     NetScaler Push                push                 OFF

To enable the responder feature by using the GUI:

  1. In the navigation pane, expand System, and then click Settings.
  2. In the details pane, under Modes and Features, click Change advanced features.
  3. In the Configure Advanced Features dialog box, select the Responder check box, and then click OK.
  4. In the Enable/Disable Feature(s)? dialog box, click YES. A message appears in the status bar, stating that the feature has been enabled.
Enable the responder feature

In this article