ADC

Bind a policy to a virtual server

May 2, 2023

Contributed by:

S S

A globally bound policy applies to all load balancing and content switching virtual servers.

Note that when binding a policy to a virtual server, you must identify it as a request-time or a response-time policy.

Bind a policy to a load balancing or content switching virtual server by using the CLI

At the command prompt, type the following commands to bind a policy to a load balancing or content switching virtual server and verify the configuration:

-  bind lb|cs vserver <virtualServerName> -policyName <policyName> -priority <positiveInteger> -type REQUEST|RESPONSE

-  show lb vserver <name>

Example:

> bind lb vserver lbvip -policyName ns_cmp_msapp -priority 50
Done
> show lb vserver lbvip
            lbvip (8.7.6.6:80) - HTTP       Type: ADDRESS
            State: DOWN
            Last state change was at Wed Jul 15 05:54:24 2009 (+226 ms)
            Time since last state change: 28 days, 01:57:26.350
            Effective State: DOWN
            Client Idle Timeout: 180 sec
            Down state flush: ENABLED
            Disable Primary Vserver On Down : DISABLED
            Port Rewrite : DISABLED
            No. of Bound Services :  0 (Total)       0 (Active)
            Configured Method: LEASTCONNECTION
            Mode: IP
            Persistence: NONE
            Vserver IP and Port insertion: OFF
            Push: DISABLED  Push VServer:
            Push Multi Clients: NO
            Push Label Rule: none

    1)      Policy : ns_cmp_msapp Priority:50
    2)      Policy : cf-pol Priority:1      Inherited
Done
 

Bind a policy to an SSL offload virtual server by using the CLI

At the command prompt, type the following commands to bind a policy to an SSL offload virtual server and verify the configuration:

bind ssl vserver <vServerName>@ -policyName <policyName> -priority <positiveInteger>

Bind a policy to a virtual server by using the GUI

In the navigation pane, expand Traffic Management > Load Balancing, Traffic Management > Content Switching, Traffic Management > SSL Offload, Security > AAA- Application Traffic, or NetScaler Gateway, and then click Virtual Servers.
In the details pane, double-click the virtual server to which you want to bind the policy, and then click Open.
On the Policies tab, click the icon for the type of policy that you want to bind (the choices are feature-specific), and then click the name of the policy. Note that for some features, you can bind both classic policies and policies that use the Advanced policy to the virtual server.
If you are binding a policy to a Content Switching virtual server, in the Target field select a load balancing virtual server to which traffic that matches the policy is sent.
Click OK. A message in the status bar indicates that the policy is bound successfully.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Bind a policy to a virtual server

May 2, 2023

Contributed by:

S S

Bind a policy to a virtual server

Bind a policy to a load balancing or content switching virtual server by using the CLI

Bind a policy to an SSL offload virtual server by using the CLI

Bind a policy to a virtual server by using the GUI

In this article