ADC

Configure and bind a traffic rate policy

December 21, 2023

Contributed by:

C S S

You implement rate-based application behavior by configuring a policy in an appropriate NetScaler feature. The feature must support Advanced policies. The policy expression must contain the following expression prefix to enable the feature to analyze the traffic rate:

sys.check_limit(<limit_identifier>)
<!--NeedCopy-->

Where limit_identifier is the name of a limit identifier.

The policy expression must be a compound expression that contains at least two components:

An expression that identifies traffic to which the rate limit identifier is applied. For example:

    http.req.url.contains("my_aspx.aspx").
<!--NeedCopy-->

An expression that identifies a rate limit identifier, for example, sys.check_limit(“my_limit_identifier”). This must be the last expression in the policy expression.

To configure a rate-based policy by using the command line interface

At the command prompt, type the following command to configure a rate-based policy and verify the configuration:

add cache|dns|rewrite|responder policy <policy_name> -rule expression && sys.check_limit("<LimitIdentifierName>") [<feature-specific information>]
<!--NeedCopy-->

Following is a complete example of a rate-based policy rule. Note that this example assumes that you have configured the responder action, send_direct_url, that is associated with the policy. Note that the sys.check_limit parameter must be the last element of the policy expression:

add responder policy responder_threshold_policy "http.req.url.contains("myindex.html") && sys.check_limit("my_limit_identifier")" send_direct_url
<!--NeedCopy-->

For information about binding a policy globally or to a virtual server, see “Binding Advanced policy Policies.”

To configure a rate-based policy by using the configuration utility

In the navigation pane, expand the feature in which you want to configure a policy (for example, Integrated Caching, Rewrite, or Responder), and then click Policies.
In the details pane, click Add. In Name, enter a unique name for the policy.
Under Expression, enter the policy rule, and make sure that you include the sys.check_limit parameter as the final component of the expression. For example:
```
http.req.url.contains("my_aspx.aspx") && sys.check_limit("my_limit_identifier")

```
Enter feature-specific information about the policy.

For example, you may be required to associate the policy with an action or a profile. For more information, see the feature-specific documentation.
Click Create, and then click Close.
Click Save.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Configure and bind a traffic rate policy

December 21, 2023

Contributed by:

C S S

December 21, 2023

Contributed by:

C S S

Configure and bind a traffic rate policy

To configure a rate-based policy by using the command line interface

To configure a rate-based policy by using the configuration utility

In this article