ADC

Disable TLS 1.0 and TLS 1.1 on NSIP

May 2, 2023

Contributed by:

S S C

To disable TLS 1.0 and TLS 1.1 on NSIP by using the GUI

Navigate to Traffic Management > Load Balancing > Services.
On the Services page, click the Internal Services tab, select the check box next to the internal service for NSIP to be edited, and click Edit.

Note: There might be different services for NSIP for different secure ports. Make the required changes on all the applicable ports individually.
Click the pencil icon under SSL Parameters section to disable the required TLS.
Finally click OK and click Done.

Note: If the NetScaler appliance is in a high availability setup, the TLS must be disabled on both the nodes individually.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Disable TLS 1.0 and TLS 1.1 on NSIP

May 2, 2023

Contributed by:

S S C

May 2, 2023

Contributed by:

S S C

Disable TLS 1.0 and TLS 1.1 on NSIP

In this article