Enable the responder feature
To use the Responder feature, you must first enable it.
To enable the responder feature by using the NetScaler CLI:
At the command prompt, type the following commands to enable the responder feature and verify the configuration:
-
enable ns feature <feature> -
show ns feature
Example:
enable ns feature Responder
Done
> show ns feature
Feature Acronym Status
------- ------- ------
1) Web Logging WL ON
2) Surge Protection SP ON
.
.
.
19) Responder RESPONDER ON
20) NetScaler Push push OFF
Done
>
To enable the responder feature by using the GUI:
-
In the navigation pane, expand System, and then click Settings.
-
In the details pane, under Modes and Features, click Change advanced features.
-
In the Configure Advanced Features dialog box, select the Responder check box, and then click OK.
-
In the Enable/Disable Feature(s)? dialog box, click YES. A message appears in the status bar, stating that the feature has been enabled.