ADC

Configuring failover interface set

May 2, 2023

Contributed by:

A Failover Interface Set (FIS) is a logical group of interfaces. In an HA configuration, using a FIS is a way to prevent failover by grouping interfaces so that, when one interface fails, other functioning interfaces are still available. A FIS can also be configured for the nodes of a NetScaler cluster.

HA MON interfaces that are not bound to an FIS are known as critical interfaces (CI) because if any of them fails, failover is triggered.

Note:

An FIS does not create an active and standby configuration. It also does not prevent bridging loops when connecting to links to the same VLAN.

Creating or Modifying an FIS

To add an FIS and bind interfaces to it by using the command line interface

At the command prompt, type:

add fis <name>
bind fis \<name\> \<ifnum\> ...
show fis \<name\>

Example

> add fis fis1
 Done
> bind fis fis1 1/3 1/5
 Done
<!--NeedCopy-->

An unbound interface becomes a critical interface (CI) if it is enabled and HA MON is on.

To unbind an interface from an FIS by using the command line interface

At the command prompt, type:

unbind fis \<name\> \<ifnum\> ...
show fis \<name\>

Example

> unbind fis fis1 1/3
 Done
<!--NeedCopy-->

To configure an FIS by using the GUI

Navigate to System > High Availability and, on the Failover Interface Set tab, add a new FIS, or edit an existing FIS.

Removing an FIS

When the FIS is removed, its interfaces are marked as critical interfaces.

To remove an FIS by using the command line interface

At the command prompt, type:

rm fis <name>

Example

> rm fis fis1
  Done
<!--NeedCopy-->

To remove an FIS by using the GUI

Navigate to System > High Availability and, on the Failover Interface Set tab, delete the FIS.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Configuring failover interface set

May 2, 2023

Contributed by:

May 2, 2023

Contributed by:

Configuring failover interface set

Creating or Modifying an FIS

To add an FIS and bind interfaces to it by using the command line interface

To unbind an interface from an FIS by using the command line interface

To configure an FIS by using the GUI

Removing an FIS

To remove an FIS by using the command line interface

To remove an FIS by using the GUI

In this article