Citrix SD-WAN Orchestrator

Address resolution protocol

December 16, 2020

Contributed by:

In Citrix SD-WAN deployments such as Gateway and One-arm, when the Address Resolution Protocol (ARP) requests are received frequently, the access points become overloaded affecting traffic flow. To overcome the traffic overload, you can configure the following ARP timers to send the ARP requests with specific interval times.

Gateway ARP Timer (ms): The time, (range: 100–20000 milliseconds), between ARP requests for configured Gateway IP addresses.
Host ARP Timer (ms): The time, (range: 1000–180000 milliseconds), between ARP requests for configured Host IP addresses.

ARP

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Address resolution protocol

December 16, 2020

Contributed by:

December 16, 2020

Contributed by:

Address resolution protocol

In this article