Citrix SD-WAN

Session-based HTTP Notifications

March 12, 2021

Contributed by:

S C

You can now configure event and alarm reporting for generic HTTP POST API service requests in the Citrix SD-WAN appliance GUI. The HTTP alarm and event notification configuration are similar to the email and SNMP events for events and alarms supported in SD-WAN.

The session based HTTP Post notification is sent to an external service; such as Service Now. The event notifications for HTTP server can be configured in the Citrix SD-WAN appliance GUI and Citrix SD-WAN Center.

To configure HTTP POST notifications in the Citrix SD-WAN appliance GUI:

Navigate to Configuration > Logging/Monitoring > HTTP Server.
Click Enable HTTP Messages.
Enter Server URL of the HTTP server for which you want to receive notifications from. Enter the Server UserName and Server Password.
Click Apply Settings. The page refreshes after the HTTP server notifications settings are applied.

Note

Use the Send Test Message option to verify that the HTTP server connection is successful.

To add Alarm notification for HTTP server session:

In the Logging/Monitoring page, go to the Alarm Options tab page.
Click Add Alarm.
Select an Event Type from the drop-down list.
Select following alarm notification states for the chosen Event Type. The trigger state and clear state change according to the selected Event Type.
- Trigger State – GOOD, DISABLED, BAD, DEAD
- Trigger Duration – time in seconds
- Clear State - GOOD, DISABLED, BAD, DEAD
- Clear Duration – time in seconds
- Severity – DEBUG, INFO, NOTICE, WARNING, ERROR, CRITICAL, EVENT, EMERGENCY
Select the Syslog and HTTP checkboxes to receive notifications specific to the Syslog and HTTP server events. Click Apply Settings.

To configure event options:

Go to the Alert Options tab page. Under General Event Configuration page; select the HTTP server notification filter for an Event Type and click Apply Settings.

HTTP
HTTP Severity Filter

localized image

Configure HTTP Notifications in Citrix SD-WAN Center

To configure HTTP notifications:

Navigate to Fault > Notification Settings > HTTP.
Enter the Server URL, Server UserName, and Server Password for the HTTP server.
Click Apply

To configure severity settings:

Go to the Severity Settings page. Click Enable to start monitoring HTTP notifications for a chosen Event Type.
You can choose to monitor Email, Syslog, SNMP, and HTTP event notifications for the following Event Types. Click Apply.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Session-based HTTP Notifications

March 12, 2021

Contributed by:

S C

March 12, 2021

Contributed by:

S C

Session-based HTTP Notifications

Configure HTTP Notifications in Citrix SD-WAN Center

In this article