ADC

Configure persistence types that do not require a rule

August 20, 2024

Contributed by:

C C

To configure persistence, you must first set up a load balancing virtual server, as described in Setting Up Basic Load Balancing. You then configure persistence on the virtual server.

To configure persistence on a virtual server by using the CLI

At the command prompt, type the following commands to configure persistence and verify the configuration:

set lb vserver <name> -PersistenceType <type> [-timeout <integer>]

show lb vserver  
<!--NeedCopy-->

Example:

set lb vserver Vserver-LB-1 -persistenceType SOURCEIP -timeout 60

show lb vserver
<!--NeedCopy-->

Timeout is the time period for which a persistence session is in effect. The timeout default and minimum values (in minutes) vary based on the persistence type as listed in the following table.

persistence type	Default value	Minimum value	Maximum value
Cookie insert/group cookie insert	2	0	1440
Other persistence types	2	2	1440

Note

Group cookie insert persistence type can be set on the load balancing group.

For IP-based persistence, you can also set the persistMask parameter.

The persistence type by default is set to NONE.

To configure persistence on a virtual server by using the GUI

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open the virtual server.
In the Persistence section, choose the persistence type that meets your requirement. The most suitable persistence type for the virtual server is available as option buttons. Other persistence types that are applicable to the specific virtual server type can be selected from the Others list.

Note Prior to Citrix ADC release 12.0 build 56.20, all persistence types are available in a single Persistence drop-down list without any option buttons.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure persistence types that do not require a rule

August 20, 2024

Contributed by:

C C

August 20, 2024

Contributed by:

C C

Configure persistence types that do not require a rule

To configure persistence on a virtual server by using the CLI

To configure persistence on a virtual server by using the GUI

In this article