ADC

Configure load monitors

August 20, 2024

Contributed by:

C C

To configure a load monitor, first create the load monitor. For instructions on creating a monitor, see Creating Monitors. Next, select or create the metric table to define a set of metrics that determine the state of the server, and (if you create a metric table) bind each metric to the metric table.

To create a metric table by using the command line interface

At the command prompt, type the following commands:

add lb metricTable <metricTableName>

bind lb metricTable <metricTableName> <metric> <SNMPOID>
<!--NeedCopy-->

Example:

add lb metricTable Table-Custom-1

bind lb metricTable Table-Custom-1 1.3.6.1.4.1.5951.4.1.1.41.1.5 11
<!--NeedCopy-->

To create a metric table and bind metrics to it by using the configuration utility

Navigate to Traffic Management > Load Balancing > Metric Tables and create a metric table.
To bind metrics, click Bind and specify a metric and an SNMP OID.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure load monitors

August 20, 2024

Contributed by:

C C

August 20, 2024

Contributed by:

C C

Configure load monitors

To create a metric table by using the command line interface

To create a metric table and bind metrics to it by using the configuration utility

In this article