ADC

Enable access to services when down

August 20, 2024

Contributed by:

C C S

You can enable access to a service when it is disabled or in a DOWN state by configuring the Citrix ADC appliance to use Layer 2 mode to bridge the packets sent to the service. Normally, when requests are forwarded to services that are DOWN, the request packets are dropped. When you enable the Access Down setting, however, these request packets are sent directly to the load balanced servers.

For more information about Layer 2 and Layer 3 modes, see IP Addressing.

For the appliance to bridge packets sent to the DOWN services, enable Layer 2 mode with the accessDown parameter.

To enable access down on a service by using the CLI

At the command prompt, type:

set service <name> -accessDown <Value>
<!--NeedCopy-->

Example:

set service Service-HTTP-1 -accessDown YES
<!--NeedCopy-->

To enable access down on a service by using the GUI

Navigate to Traffic Management > Load Balancing > Services, and open a service.
In Advanced Settings, select Traffic Settings, and select Access Down.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Enable access to services when down

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Enable access to services when down

To enable access down on a service by using the CLI

To enable access down on a service by using the GUI

In this article