ADC

Modify monitors

August 20, 2024

Contributed by:

C C S

You can modify the settings for any monitor that you created.

Note: Two sets of parameters apply to monitors: those that apply to all monitors, regardless of type, and those that are specific to a monitor type. For information on parameters for a specific monitor type, see the description for that type of monitor.

To modify an existing monitor by using the command line interface

At the command prompt, type:

set lb monitor <monitorName> <type> -interval <interval> -resptimeout <resptimeout>
<!--NeedCopy-->

Example:

set mon monitor-HTTP-1 HTTP -interval 50 milli
-resptimeout 20 milli
<!--NeedCopy-->

To modify an existing monitor by using the configuration utility

Navigate to Traffic Management > Load Balancing > Monitors, and open a monitor to modify.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Modify monitors

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Modify monitors

To modify an existing monitor by using the command line interface

To modify an existing monitor by using the configuration utility

In this article