ADC

Configure the prefer direct route option

August 20, 2024

Contributed by:

C C S

On a wildcard load balancing virtual server if you explicitly configure a route to a destination, by default, the Citrix ADC appliance forwards traffic according to the configured route. If you want the appliance to not look up for the configured route, you can set the Prefer Direct Route option to NO.

If a device is directly connected to a Citrix ADC appliance, the appliance directly forwards traffic to the device. For example, if the destination of a packet is a firewall, the packet need not be routed through another firewall. However, in some cases, you may want the traffic to go through the firewall even if the device is directly connected to it. In such cases, you can set the Prefer Direct Route Option to NO.

Note: The preferDirectRoute setting is applicable to all the wildcard virtual servers on the Citrix ADC appliance.

To set the prefer direct route option by using the CLI

At the command prompt, type:

set lb parameter -preferDirectRoute (YES | NO)
<!--NeedCopy-->

Example:

set lb parameter -preferDirectRoute YES
<!--NeedCopy-->

To set the prefer direct route option by using the GUI

Navigate to Traffic Management > Load Balancing > Configure Load Balancing parameters.
Select Prefer Direct Route.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure the prefer direct route option

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Configure the prefer direct route option

To set the prefer direct route option by using the CLI

To set the prefer direct route option by using the GUI

In this article