ADC

Configure backup persistence

August 20, 2024

Contributed by:

C C S

You can configure a virtual server to use source IP persistence type when the primary persistence type fails.

The following table describes the combinations of primary and secondary backup persistence types, and the conditions when the backup persistence is used.

Primary persistence	Backup persistence	When the primary persistence lookup fails…
Cookie Insert	Source IP	The appliance falls back to source-IP based persistence only when the client browser does not return any cookie in the request. However, if the browser returns a cookie (not necessarily the persistence cookie) it is assumed that the browser supports cookies and hence backup persistence is not triggered.
Rule	Source IP	The appliance uses source-IP based persistence when the parameter specified in the rule is missing in the incoming request.

Note

If the primary persistence type is HTTP-Cookie based persistence, and the backup persistence type is Source IP-based, you can set a timeout value for backup persistence. For instructions, see Setting a Timeout Value for Idle Client Connections.

You cannot set a timeout value for backup persistence when the primary persistence is rule based, because in that case the timeout value for secondary persistence must be the same as for the primary persistence. Therefore, the primary and secondary expire at the same time.

To set backup persistence for a virtual server by using the command line interface

At the command prompt, type:

set lb vserver <name> -persistenceType <PersistenceType> -persistenceBackup <BackupPersistenceType>
<!--NeedCopy-->

Example:

set lb vserver Vserver-LB-1 -persistenceType CookieInsert -persistenceBackup SourceIP

set lb vserver Vserver-LB-1 -persistenceType sslsession -persistenceBackup SourceIP

set lb vserver Vserver-LB-1 –persistenceType RULE –rule http.req.header("User-Agent").value(0).contains("MyBrowser") –persistenceBackup SOURCEIP

set lb vserver Vserver-LB-1 -persistenceType sslsession -persistenceBackup SourceIP
<!--NeedCopy-->

To set backup persistence for a virtual server by using the configuration utility

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open the virtual server.
In Advanced Settings, select Persistence, and specify a backup persistence type.

Note: The primary persistence must be set to COOKIEINSERT, RULE, or SSLSESSION.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure backup persistence

August 20, 2024

Contributed by:

C C S

August 20, 2024

Contributed by:

C C S

Configure backup persistence

To set backup persistence for a virtual server by using the command line interface

To set backup persistence for a virtual server by using the configuration utility

In this article