Citrix SD-WAN Platforms

SD-WAN 2000 Appliance with Windows Server

May 23, 2019

Contributed by:

The Citrix SD-WAN 2000 with Windows Server platform is a 1U appliance with 1 quad-core processor and 24 gigabytes (GB) of memory.

The following figure shows the front panel of the SD-WAN 2000 appliance with Windows Server.

Figure 1. Citrix SD-WAN 2000 appliance with Windows Server, front panel

Note: You cannot assign apA ports to Windows Server. However, you can assign AUX port to Windows Server

localized image

SD-WAN 2000 appliance with Windows Server has the following ports:

An RS232 serial console port.
A copper Ethernet (RJ45) Port called the Lights out Management (LOM) port. You can use this port to remotely monitor and manage the appliance independently of the appliance’s software.
A copper Ethernet (RJ45) management port, numbered 0/1, and named PRI (primary). The management port is used to connect directly to the appliance for system administration functions. You can use this port for initial provisioning of WAN optimization and Windows Server.

Note: The LOM port also operates as a management port.
Four 10/100/1000Base-T copper Ethernet ports numbered 1/1, 1/2, 1/3, and 1/4 from left to right. The four ports form two accelerated pairs, which function as accelerated bridges. Ports 1/1 and 1/2 are accelerated pair A (apA), and 1/3 and 1/4 are accelerated pair B (apB).

The following figure shows the back panel of the SD-WAN 2000 appliance with Windows Server.

Figure 2. Citrix SD-WAN 2000 appliance with Windows Server, back panel

localized image

The following components are visible on the back panel of the SD-WAN 2000 appliance with Windows Server:

600 GB removable solid-state drive, which stores the appliance’s software and user data, and 1 TB hard disk drive.
Power switch, which switches power to the appliance on or off. Press the switch for five seconds to switch off the power.
USB port (reserved for a future release).
Non-maskable interrupt (NMI) button, for use at the request of Technical Support to produce a core dump. You must use a pen, pencil, or other pointed object to press this red button, which is recessed to prevent unintentional activation.
Single power supply, rated at 300 watts, 100–240 volts.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

SD-WAN 2000 Appliance with Windows Server

May 23, 2019

Contributed by:

May 23, 2019

Contributed by:

SD-WAN 2000 Appliance with Windows Server

In this article