Citrix SD-WAN Platforms

Initial Configuration

August 22, 2022

Contributed by:

H C

The appliance shipped from Citrix has default IP addresses configured on it. To deploy the appliance on the network, you must configure the appropriate IP addresses on the appliance to accelerate the network traffic.

You can connect the ethernet cable to the appliance management port, and login to the web management interface using the default IP address.

To perform initial configuration:

Identify the prerequisites for the initial configuration.
Record various values required in the initial configuration procedure.
Configure the appliance by connecting it to the Ethernet port.
Perform additional configuration for Windows.
Assign management IP address through the serial console.
Troubleshoot initial configuration issues.

By default, the initial configuration deploys the appliance in inline mode. If you are configuring a hardware SD-WAN appliance, physically connect the appliance to a PC.

Note

On the SD-WAN 410-SE appliance, the default static IP address is 192.168.100.1. It also has DHCP enabled (by default) for Management access. When you enable the SD-WAN service, or install SD-WAN license using default static IP (192.168.100.1), this IP is lost.

You should assign a static IP address or be notified of the DHCP IP address that is assigned to this appliance. In order to see the DHCP IP address, you can log into the SD-WAN command line interface using admin/password, to view the management IP address. The LCD console on the 410-SE appliance does not display the IP address.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Initial Configuration

August 22, 2022

Contributed by:

H C

August 22, 2022

Contributed by:

H C

Initial Configuration

In this article