ADC

Use the source IP address of the client when connecting to the server

September 14, 2021

Contributed by:

S C

You can configure the Citrix ADC appliance to forward packets from the client to the server without changing the source IP address. This is useful when you cannot insert the client IP address into a header, such as when working with non-HTTP services.

For more information about configuring USIP globally, see Enabling Use Source IP Mode.

To enable USIP mode for a service by using the CLI

At the command prompt, type:

set service <name> -usip (YES | NO)
<!--NeedCopy-->

Example:

set service Service-HTTP-1 -usip YES
<!--NeedCopy-->

To enable USIP mode for a service by using the GUI

Navigate to Traffic Management > Load Balancing > Services, and open a service.
In Advanced Settings, in the Service Settings section, select Use Source IP Address.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Use the source IP address of the client when connecting to the server

September 14, 2021

Contributed by:

S C

September 14, 2021

Contributed by:

S C

Use the source IP address of the client when connecting to the server

To enable USIP mode for a service by using the CLI

To enable USIP mode for a service by using the GUI

In this article