ADC

Ignore the upper limit on client connections for monitor probes

September 14, 2021

Contributed by:

Depending on considerations such as the capacity of a physical server, you can specify a limit on the maximum number of client connections made to any service. If you have set such a limit on a service, the Citrix ADC appliance stops sending requests to the service when the threshold is reached and resumes sending connections to the service after the number of existing connections falls to within the limits. You can configure the appliance to skip this check when it sends monitor-probe connections to a service.

Note: You cannot skip the maximum-client-connections check for an individual service. If you specify this option, it applies to all the monitors bound to all the services configured on the Citrix ADC appliance.

To set the Skip MaxClients for Monitor Connections option by using the CLI

At the command prompt, type:

set lb parameter -monitorSkipMaxClient (ENABLED|DISABLED)
<!--NeedCopy-->

Example:

set lb parameter -monitorSkipMaxClient enabled
<!--NeedCopy-->

To set the Skip MaxClients for Monitor Connections option by using the GUI

Navigate to Traffic Management > Load Balancing > Configure Load Balancing Parameters.
Select Skip MaxClients for Monitoring Connections.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Ignore the upper limit on client connections for monitor probes

September 14, 2021

Contributed by:

September 14, 2021

Contributed by:

Ignore the upper limit on client connections for monitor probes

To set the Skip MaxClients for Monitor Connections option by using the CLI

To set the Skip MaxClients for Monitor Connections option by using the GUI

In this article