ADC

Authentication profiles

September 14, 2021

Contributed by:

When you want the same authentication settings to be used by multiple traffic management virtual servers, you can create an authentication profile which specifies the authentication virtual server, the authentication host, the authentication domain, and the authentication level.

This authentication profile can be associated with the relevant traffic management virtual servers.

Configure an authentication profile

Configure an authentication profile by using the CLI

Create the authentication profile and set the required parameters.

For example, to create a profile with an authentication virtual server named “authVS”.

 add authentication authnProfile authProfile1 -authnVsName authVS -authenticationHost authnVS.example.com -authenticationDomain example.com -authenticationLevel
 <!--NeedCopy-->

Note:

The authentication weight or level depends on the virtual server to which the traffic is bound. A session that is created by authenticating against the traffic management virtual server at a given level cannot be used to access the traffic management virtual server at a higher level.

Bind the authentication profile to the relevant traffic management virtual servers.

For example, to bind authProfile1 to a load balancing virtual server named “vserver1”.
```
 set lb vserver vserver1 -authnProfile authProfile1
 
```

Configure an authentication profile by using the GUI

In the Configuration tab, navigate to Security > AAA - Application Traffic > Authentication Profile, and configure the authentication profile as required.

Note:

You can create an authentication profile by using the Citrix Gateway wizard as well. The profile contains all the settings for the authentication policy. You configure the profile when you create the authentication policy.

With the Citrix Gateway wizard, you can use the chosen authentication type to configure authentication. If you want to configure other authentication policies after running the wizard, you can use the configuration utility. For more information about the Citrix Gateway wizard, see Configuring Settings by Using the Citrix Gateway Wizard].

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Authentication profiles

September 14, 2021

Contributed by:

September 14, 2021

Contributed by:

Authentication profiles

Configure an authentication profile

Configure an authentication profile by using the CLI

Configure an authentication profile by using the GUI

In this article