ADC

GSLB methods

September 14, 2021

Contributed by:

S C

Unlike traditional DNS servers that simply respond with the IP addresses of the configured servers, a Citrix ADC appliance configured for GSLB responds with the IP addresses of the services, as determined by the configured GSLB method. By default, the GSLB virtual server is set to the least connection method. If all GSLB services are down, the appliance responds with the IP addresses of all the configured GSLB services.

GSLB methods are algorithms that the GSLB virtual server uses to select the best-performing GSLB service. After the host name in the Web address is resolved, the client sends traffic directly to the resolved service IP address.

The Citrix ADC appliance provides the following GSLB methods:

Round Robin
Least Connections
Least Response Time
Least Bandwidth
Least Packets
Source IP Hash
Custom Load
Round Trip Time (RTT)
Static Proximity

For GSLB methods to work with a remote site, either MEP must be enabled or explicit monitors must be bound to the remote services. If MEP is disabled, RTT, Least Connections, Least Bandwidth, Least Packets and Least Response Time methods default to Round Robin.

The Static Proximity and RTT load balancing methods are specific to GSLB.

Specifying a GSLB method other than static proximity or dynamic RTT

For information about the Round Robin, Least Connections, Least Response Time, Least Bandwidth, Least Packets, Source IP Hash, or Custom Load method, see Load Balancing.

To change the GSLB method by using the CLI

At the command prompt, type:

set gslb vserver <name> -lbMethod GSLBMethod
<!--NeedCopy-->

Example:

set gslb vserver Vserver-GSLB-1 -lbMethod ROUNDROBIN
<!--NeedCopy-->

To change the GSLB method by using the GUI

Navigate to Traffic Management > GSLB > Virtual Servers.
In the details pane, select a GSLB virtual server and click Open.
In the Configure GSLB Virtual Server dialog box, on the Method and Persistence tab, under Method, select a method from the Choose Method list.
Click OK, and verify that the method you selected appears under Details at the bottom of the screen.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

GSLB methods

September 14, 2021

Contributed by:

S C

September 14, 2021

Contributed by:

S C

GSLB methods

Specifying a GSLB method other than static proximity or dynamic RTT

To change the GSLB method by using the CLI

To change the GSLB method by using the GUI

In this article