ADC

Limit the number of concurrent requests on a client connection

August 1, 2023

Contributed by:

You can limit the number of concurrent requests on a single client connection. You can protect the servers from security vulnerabilities by limiting the number of concurrent requests. When the client connection reaches the specified maximum limit, the NetScaler appliance drops subsequent requests on the connection until the outstanding request count goes below the limit.

You can configure the maxPipelineNat parameter to limit the number of concurrent requests on a single client connection. This parameter is applicable only to the following service types and when “svrTimeout” is set to zero:

ANY
All UDP service types except DNS

The default value of maxPipelineNat parameter is 255. A value of zero (0) applies no limit to the number of concurrent requests. When no limit is set, the NetScaler appliance executes all requests.

Note

If you set MaxpipelineNAT to a higher value, then the probability of spoofing attack can be higher. Hence, it is recommended to set MaxpipelineNAT to a lower value.

To limit the number of concurrent connections for a client by using the CLI

At the command prompt, type:

set lb parameter -maxPipelineNat <positive_integer>
<!--NeedCopy-->

Example:

set lb parameter -maxPipelineNat 199
<!--NeedCopy-->

To limit the number of concurrent connections for a client by using the GUI

Navigate to Traffic Management > Load Balancing > Configure Load Balancing Parameters, specify a value for Max Pipeline NAT requests.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Limit the number of concurrent requests on a client connection

August 1, 2023

Contributed by:

August 1, 2023

Contributed by:

Limit the number of concurrent requests on a client connection

To limit the number of concurrent connections for a client by using the CLI

To limit the number of concurrent connections for a client by using the GUI

In this article