ADC

Configuring a responder policy

October 3, 2024

Contributed by:

C C S

After you configure a responder action, you must next configure a responder policy to select the requests to which the NetScaler appliance should respond. A responder policy is based on a rule, which consists of one or more expressions. The rule is associated with an action, which is performed if a request matches the rule.

Note:

For creating and managing responder policies, the GUI provides assistance that is not available at the CLI.

Configure a responder policy by using the CLI

At the command prompt, type:

add responder policy <name> <expression> <action> [<undefaction>]-appFlowaction <actionName>
show responder policy <name>

Example:

> add responder policyThree "CLIENT.IP.SRC.IN_SUBNET(222.222.0.0/16)" RESET
 Done
> show responder policy policyThree

        Name: policyThree
        Rule: CLIENT.IP.SRC.IN_SUBNET(222.222.0.0/16)
        Responder Action: RESET
        UndefAction: Use Global
        Hits: 0
        Undef Hits: 0
 Done
<!--NeedCopy-->

Modify an existing responder policy by using the CLI

At the command prompt, type:

set responder policy <name> [-rule <expression>] [-action <string>] [-undefAction <string>]
show responder policy <name>

Remove a responder policy by using the CLI

At the command prompt, type:

rm responder policy <name>
show responder policy

Example:

>rm responder policy pol404Error
 Done

> show responder policy
 Done
<!--NeedCopy-->

Configure a responder policy by using the GUI

Navigate to AppExpert > Responder > Policies.
In the details pane, do one of the following:
- To create a policy, click Add.
- To modify an existing policy, select the policy, and then click Open.
Click Create or OK, depending on whether you want to create a policy or modify an existing policy.
Click Close. A message appears in the status bar, stating that the feature has been configured.

Note:

The HTTP.REQ based expressions don’t work with the SSL_BRIDGE protocol type.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring a responder policy

October 3, 2024

Contributed by:

C C S

October 3, 2024

Contributed by:

C C S

Configuring a responder policy

Configure a responder policy by using the CLI

Modify an existing responder policy by using the CLI

Remove a responder policy by using the CLI

Configure a responder policy by using the GUI

In this article