ADC

Create a DNS service

August 1, 2023

Contributed by:

A DNS service is a representation, on the NetScaler appliance, of a physical DNS server in the network. A DNS load balancing virtual server sends DNS requests to the DNS server in the network through such a service.

Create a DNS service by using the CLI

At the command line, type the following commands to create a DNS service and verify the configuration :

-  add service <name> <IP> <serviceType> <port>
-  show service [<name>]
<!--NeedCopy-->

Example:

add service Service-DNS-1 10.102.29.41 DNS 53
show service Service-DNS-1
        Service-DNS-1 (10.102.29.41:53) - DNS
        State: DOWN
        Last state change was at Fri Jul  2 10:14:32 2010
        Time since last state change: 0 days, 00:00:13.550
        Server Name: 10.102.29.41
        Server ID : 0   Monitor Threshold : 0
        Max Conn: 0     Max Req: 0      Max Bandwidth: 0 kbits
        Use Source IP: NO
        Client Keepalive(CKA): NO
        Access Down Service: NO
        TCP Buffering(TCPB): NO
        HTTP Compression(CMP): NO
        Idle timeout: Client: 120 sec   Server: 120 sec
        Client IP: DISABLED
        Cacheable: NO
        SC: OFF
        SP: OFF
        Down state flush: ENABLED

1)      Monitor Name: ping-default
                State: DOWN     Weight: 1
                Probes: 3       Failed [Total: 3 Current: 3]
                Last response: Failure - Probe timed out.
                Response Time: 2000.0 millisec
 Done
<!--NeedCopy-->

Add a DNS service by using the GUI

Navigate to Traffic Management > Load Balancing > Services.
In the details pane, click Add.
In the Create Service dialog box, specify values for the following parameters as shown:
- Service Name*—name
- Server*—IP
- Port*—port

*A required parameter

In the Protocol* drop down list, select a supported protocol (for example, DNS).
Click Create, and then click Close.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Create a DNS service

August 1, 2023

Contributed by:

August 1, 2023

Contributed by:

Create a DNS service

Create a DNS service by using the CLI

Add a DNS service by using the GUI

In this article