ADC

Set a time-out value for idle client connections

August 1, 2023

Contributed by:

You can configure a virtual server to terminate any idle client connections after a configured time-out period (in seconds) elapses. When you configure this setting, the NetScaler appliance waits for the time you specify and, if the client is idle after that time, it closes the client connection. By default, the client idle time-out value is set to 180 seconds.

To set a time-out value for idle client connections by using the CLI

At the command prompt, type:

set lb vserver <name> -cltTimeout <Value>
<!--NeedCopy-->

Example:

set lb vserver Vserver-LB-1 -cltTimeout 100
<!--NeedCopy-->

To set a time-out value for idle client connections by using the GUI

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open a virtual server.
In Advanced Settings, click Traffic Settings, and set the client idle time-out value in seconds.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Set a time-out value for idle client connections

August 1, 2023

Contributed by:

August 1, 2023

Contributed by:

Set a time-out value for idle client connections

To set a time-out value for idle client connections by using the CLI

To set a time-out value for idle client connections by using the GUI

In this article