Enable the responder feature

December 21, 2023

Contributed by:

C S

To use the Responder feature, you must first enable it.

To enable the responder feature by using the NetScaler CLI:

At the command prompt, type the following commands to enable the responder feature and verify the configuration:

enable ns feature <feature>
show ns feature

Example:

enable ns feature Responder
 Done
> show ns feature

        Feature                        Acronym              Status
        -------                        -------              ------
 1)     Web Logging                    WL                   ON
 2)     Surge Protection               SP                   ON
 .
 .
 .
 19)     Responder                      RESPONDER            ON
 20)     NetScaler Push                push                 OFF
 Done
>
<!--NeedCopy-->

To enable the responder feature by using the GUI:

In the navigation pane, expand System, and then click Settings.
In the details pane, under Modes and Features, click Change advanced features.
In the Configure Advanced Features dialog box, select the Responder check box, and then click OK.
In the Enable/Disable Feature(s)? dialog box, click YES. A message appears in the status bar, stating that the feature has been enabled.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Enable the responder feature

December 21, 2023

Contributed by:

C S

December 21, 2023

Contributed by:

C S

Enable the responder feature

In this article