ADC

Configure edge mode

September 14, 2021

Contributed by:

When deployed at the edge of a network, the Citrix ADC appliance dynamically learns about the servers on that network. Edge mode enables the appliance to dynamically learn about up to 40,000 HTTP servers and proxy TCP connections for these servers.

This mode turns on the collection of statistics for the dynamically learned services and is typically used in transparent deployments for cache redirection.

Enable edge mode by using the CLI

At the command prompt, type the following commands to enable edge mode and verify the setting:

-  enable ns mode Edge  
-  show ns mode  
<!--NeedCopy-->

Example:

> enable ns mode edge
 Done

> show ns mode

        Mode                           Acronym              Status
        -------                        -------              ------
          ...
          ...
          ...
 6)     MAC-based forwarding           MBF                  ON
 7)     Edge configuration             Edge                 ON
 8)     Use Subnet IP                  USNIP                OFF
          ...
          ...
          ...
 16)    Bridge BPDUs                   BridgeBPDUs          OFF
 Done
<!--NeedCopy-->

Enable edge mode by using the GUI

In the navigation pane, expand System, and then click Settings.
In the details pane, under Modes and Features, click Configure modes.
In Configure Modes dialog box, select the check box next to the Edge Configuration, and then click OK.
In Enable/Disable Feature(s)? dialog box, click Yes.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure edge mode

September 14, 2021

Contributed by:

September 14, 2021

Contributed by:

Configure edge mode

Enable edge mode by using the CLI

Enable edge mode by using the GUI

In this article