Configure the lower-tier Citrix ADC appliances

September 14, 2021

Contributed by:

S C

Configure each of the lower-tier Citrix ADC appliances as follows.

Configure a lower-tier appliance for n-tier cache redirection by using the CLI

At the command prompt, type the following commands:

add service <name>@ <cacheServiceIP> <serviceType> <port> -cip ENABLED "ClientIP" –cachetype transparent

Repeat for each cache server.
add lb vserver <name>@ <serviceType> -m MAC
bind lb vserver <name>@ <cacheServiceName>

Repeat for each cache server.
add cr vserver <name> <serviceType> * <port> -srcIPExpr "HTTP.REQ.HEADER("ClientIP")" -originusip ON –usePortRange ON
set ns param-crPortRange <startPortNumber-endPortNumber>

Configure a lower-tier appliance for n-tier cache redirection by using the GUI

Create a service for each cache server. To create a service:
1. Navigate to Traffic Management > Load Balancing > Services.
2. In the details pane, click Add, and specify the name and protocol. Clear the Directly Addressable check box.
3. In the Advanced tab, select the Override Global check box and the Client IP check box, and then in the Header box, type ClientIP.
4. In the Cache Type box, select Transparent Cache.
5. Click Create.
Configure a load balancing virtual server:
1. Navigate to Traffic Management > Load Balancing > Virtual Services.
2. In the details pane, click Add and specify the name, protocol, IP address, and port. The IP address should be an asterisk (*).
3. In the Services tab, select the services that represent the cache servers.
4. In the Advanced tab, for Redirection Mode, select MAC Based.
5. Click Create.
Configure a cache redirection virtual server:
1. Navigate to Traffic Management > Load Balancing > Virtual Services.
2. In the details pane, click Add and specify the name, protocol, IP address, and port. The IP address should be *.
3. For Cache Type, select Transparent.
4. On the Advanced tab, in the Cache Server box, select the new load balancing virtual server and check the Origin USIP and Use Port Range check boxes. In the Source IP Expression box, type HTTP.REQ.HEADER(“ClientIP”).
5. Click Create.
Assign a source port range for the appliance:
1. In the navigation pane, click System, and then click Settings.
2. In the Settings group, click the Change global system settings link.
3. In the Cache Redirection Port Range group, specify the port range for the appliance by typing a port number for Start Port and a port number for End Port.
4. Click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure the lower-tier Citrix ADC appliances

September 14, 2021

Contributed by:

S C

September 14, 2021

Contributed by:

S C

Configure the lower-tier Citrix ADC appliances

Configure a lower-tier appliance for n-tier cache redirection by using the CLI

Configure a lower-tier appliance for n-tier cache redirection by using the GUI

In this article