ADC

Synchronizing cluster configurations

September 14, 2021

Contributed by:

Citrix ADC configurations that are available on the configuration coordinator are synchronized to the other nodes of the cluster when:

A node joins the cluster
A node rejoins the cluster
A new command is run through the cluster IP address

Also, you can forcefully synchronize the configurations that are available on the configuration coordinator (full synchronization) to a specific cluster node. Make sure you synchronize one cluster node at a time, otherwise the cluster can get affected.

To synchronize cluster configurations by using the CLI

At the command prompt of the appliance on which you want to synchronize the configurations, type:

force cluster sync

To synchronize cluster configurations by using the GUI

Log on to the appliance on which you want to synchronize the configurations.
Navigate to System > Cluster.
In the details pane, under Utilities, click Force cluster sync.
Click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Synchronizing cluster configurations

September 14, 2021

Contributed by:

September 14, 2021

Contributed by:

Synchronizing cluster configurations

To synchronize cluster configurations by using the CLI

To synchronize cluster configurations by using the GUI

In this article