ADC

Create monitors

October 16, 2023

Contributed by:

C S

The Citrix ADC appliance provides a set of built-in monitors. It also allows you to create custom monitors, either based on the built-in monitors or from scratch.

To create a monitor by using the CLI

At the command prompt, type:

add lb monitor <monitorName> <monitorType> [<interval>]

add lb mon monitor-HTTP-1 HTTP

add lb mon monitor-HTTP-2 TCP 2
<!--NeedCopy-->

To create a monitor by using the GUI

Navigate to Traffic Management> Load Balancing> Monitors.
Click Add and create a monitor type that meets your requirement.

The Create Monitor screen contains two sections, Basic Parameters and Advanced Parameters.

Depending on the monitor type, the Basic Parameters section contains the parameters that must be set for each monitor. The Advanced Parameters section contains the parameters that can be used in advanced use cases.

The following figure is a sample of a Create Monitor page of the ARP monitor type.

Create monitor

Note

Prior to NetScaler release 12.0 build 56.20, Basic Parameters and Advanced Parameters are named Standard Parameters and Special Parameters respectively.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Create monitors

October 16, 2023

Contributed by:

C S

October 16, 2023

Contributed by:

C S

Create monitors

To create a monitor by using the CLI

To create a monitor by using the GUI

In this article