ADC

Enable and disable monitors

September 17, 2024

Contributed by:

C S

By default, monitors bound to services and service groups are enabled. When you enable a monitor, the monitor begins probing the services to which it is bound. If you disable a monitor bound to a service, the state the service is determined using the other monitors bound to the service. If the service is bound to only one monitor, and if you disable the monitor, the state of the service is determined using the default monitor.

To enable a monitor by using the CLI

At the command prompt, type:

set lb monitor <monitor_name> <type> -state ENABLED
<!--NeedCopy-->

Example:

set lb monitor monitor-1 http -state ENABLED
<!--NeedCopy-->

To enable a monitor by using the GUI

Navigate to Traffic Management > Load Balancing > Monitors.
Select a monitor, and from the Action list, select Enable.

To disable a monitor by using the CLI

At the command prompt, type:

set lb monitor <monitor_name> <type> -state DISABLED
<!--NeedCopy-->

Example:

set lb monitor monitor-1 http -state DISABLED
<!--NeedCopy-->

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Enable and disable monitors

September 17, 2024

Contributed by:

C S

September 17, 2024

Contributed by:

C S

Enable and disable monitors

To enable a monitor by using the CLI

To enable a monitor by using the GUI

To disable a monitor by using the CLI

In this article